First EZboard chips!
This just in from Steve. Post your encouraging replies on the Blog comment section here.
Thought I liked to share… I didn’t have the transfer tool to put the ornament design the sample came with so i drew a basic 3 chip lay out based of the ornament design and came up with this. This was a lot of fun!!! Though… I did cut my leg. Lol. No worries, I’m fine and lessons learned. On to the next board! Steve
Good looking chips for your first go! That’s why starting on EZboard is perfect.
Get yourself a lap board to avoid any future leg slices.
I use a 1/2″x12″ x 24″ piece of MDF. Cheap, sturdy and smooth.